|
Image for illustration |
80mm Temperature Controlled Cooling Fan
with four blue LEDs
2 Ball Bearing, 12V, Noise = 18.6 -
35.02dB(A), Airflow = 15.7 - 40.17 CFM, Speed = 1250 ~ 3250 RPM.
It connects via molex connector or 3-pin fan header connector, and is
supplied with four mounting screws. |
|
92mm/9cm Fans:
 |
92mm Akasa Cooling Fan
2 Ball Bearing, 12V, Noise = 18dB(A), Airflow =
29 CFM, Speed = 1400 RPM.
It connects via molex connector or 3-pin fan header connector, and is
supplied with four mounting screws. |
|
120mm/12cm Fans:
 |
120mm Cooling Fan with
blue LEDs
It connects via molex connector and is
supplied with four screws/mounting bolts.
|
|
Fan Guards, Filters, Ducts and Bolts:
|
"Atomic" Fan
Guard - 80mm
These
"Atomic" symbol fan guards are laser cut from
stainless steel and are sure to be a great looking addition to
any case that has 80mm fans. Also, because of the design,
very little air-flow is restricted which can be a problem with
some fan guards.
|
|
|
"Biohazard" Fan Guard
- 80mm or 120mm
These "Biohazard"
symbol fan guards are laser cut from stainless steel and are
sure to be a great looking addition to any case that has 80mm
or 120mm
fans. Also, because of the design, very little air-flow is
restricted which can be a problem with some fan guards. |
|
|
|
|
80mm Fan Filters
Constructed from a wire mesh. Available in red, green, blue, or back.
These are a must for any 80mm case fan
(not included) that is drawing
air into your computer case. Along with the air that gets drawn
in, so also does dust that accumulates on components and can
clog up heatsinks and other parts. This can cause parts to
overheat, and shorten the life of expensive parts. Please order
a set of bolts from above, if required.
|
|
 |
120mm Akasa Fan Filter
If you have a 120mm / 12cm
fan drawing air into your computer case, then it is highly
recommend that you use a fan filter to help cut down on the amount
of dust and fluff that can get drawn in - especially if your
computer is sitting on or close to a floor or other dusty area.
The accumulation of dust inside your
computer can clog up fans, cause components to overheat, and even
cause parts to fail completely.
These fan filters are
constructed of a plastic surround that also acts as a guard, and a
foam filter.
|
|
 |
80mm Fan Duct
Direct airflow into your
case to ensure it reaches the vital components.
5cm deep. Extends to approx. 7cm.
|
|
 |
80mm Fan Duct
Direct airflow into your
case to ensure it reaches the vital components.
5cm deep. Extends to approx. 8cm.
|
|
|
8
x Fan Mounting Bolts
This set of 8 quality case fan mounting bolts
is included with 8 washers, nuts, and rubber washers which can
help minimise fan vibrations from resonating through your
computer case. They are also suitable for mounting fan guards
and filters.
in stock |
|
| |
Back to Top 
|
|
|
